HSCO spot weld drill bit, TIN-coated
HSCo spot-weld drill bit, TiN coated
DRL-SPTWELD-TIN-D10MM
Register now and access more than 125,000 products
Special drill bit for removing spot welds
Fixed centring point means that no centre-punching is required
Improved PLUS centring point also suitable for use on higher-strength sheet metal
The optimised tip geometry ensures a longer service life than for conventional spot-weld drill bits.
Suitable for use in any standard drill
TiN coating extends the service life of the cutting edges by two to three times
Maximum rotation speed:
- Ø 6 up to 1200 rpm
- Ø 8 up to 950 rpm
- Ø 10 up to 730 rpm
Tips for increasing the service life of the centring point:
- Do not use in drills with an impact chuck or spindles.
- Set the drill to a suitable speed; the speed of compressed-air devices is generally set too high.
Diameter | 10 mm |
Length | 88 mm |
Chip flute length | 44 mm |
Datasheets (0)
Certificates/ Documents (0)
Last viewed
1/2 inch socket wrench insert, metric
Specially fused alumina sanding tip, pink
Holder For 12 mm, 20 mm and 30 mm countersinks
Engine sealing compound, Silicone Special 250
Tool case
Flat square Accuracy 1 in accordance with DIN 875, made from carbon steel
1/4 inch socket wrench insert, metric short
Sealant remover
Logo
FPM/ECO/AR/ECO petrol hose with low permeation for fuel-carrying applications