Satin-finish wheel brush Universal, crimped, with hole
Grinding bristle brush
BRSH-PLA-SATNFINR-100X12X19MM
Register now and access more than 125,000 products
- No or only a small change in the geometry of the workpiece
- The sanding bristles work not only at the tips but also on the sides, thanks to the polyamide fibres interspersed with abrasive grain
- Seamless packing to wide rollers is possible due to the special design
- For use on angle grinders
- Only the edge tips act on the workpiece. While excessive contact pressure does not improve the result, it does increase the required drive power and reduces the service life of the brush.
- Always wear safety goggles and safety gloves when working with machine brushes!
Datasheets(X)
- Deburring, cleaning, smoothing, polishing, structuring and roughing
- Smoothing of wood surfaces
Diameter x width x drill hole (DxBxA) | 100 x 12 x 19 mm |
Max. rotation speed | 8000 rpm |
Material of wire | Polyamide fibres with silicon carbide sanding grains |
Design | Corrugated |
Suitable for satin finisher (point system) | 4 of 4 points |
Aggressiveness | Middle |
EN standard | 1083-2 |
Last viewed
Standard cable tie with plastic latch
Double hook For square holes in perforated plates, workshop trolleys and the ORSY®1 shelving systems
Wire end ferrule with plastic sleeve
Flat washer with chamfer for high-strength fittings
Hexagonal bolt with thread up to head for pressure container construction DIN EN ISO 4017, A4 stainless steel
Cut protection glove W-200 Level C
Protective glove nitrile TIGERFLEX® Plus
Twist Drill bit HSCO DIN 338 TYPE RN
Gear oil, TRIATHLON Gear Hypoid 80W-90
Combination pliers DIN ISO 5746