Nylon Sanding Fleece With shank
Nylon sanding fleece with shank
SNDDISC-NYL-SHFT6MM
Register now and access more than 125,000 products
Coarsely structured, elastic, abrasive cleaning sanding fleece made of a special combination of synthetic fibres and evenly embedded abrasive grains (silicon carbide).
Design and properties:
- flexible, open fleece structure
Ideal adjustment to workpiece geometry for optimum surface contact.
Minimal clogging with surface dust
Uniform, reproducible sanding results
Reduced heat development - cool grinding
- Continuous exposure of fresh abrasive grain
Uniform, consistent working results and a clean, residue-free surface
- Easy-to-handle sanding power
Minimised risk of damaging workpiece surface or removing too much material
- Free of metals susceptible to corrosion
No contamination of material surface
For use on electric drills, straight grinders and flexible shafts
Plastic support flanges can be broken off in steps
Round shank: 6 x 40 mm
General working and safety precautions:
The maximum permissible speeds may not be exceeded.
Work only with appropriate protective equipment, such as protective goggles, gloves, ear protectors etc.
Attention: Rough-cleaning sanding fleeces are not suitable for edge sanding. Therefore, only sand along and not against material edges!
Observe operating instructions.
Datasheets(X)
Materials to be processed:
For universal use on virtually all materials. Especially for stainless steel, steel, non-ferrous metals, wood and plastic.
Cleaning welding seams, metal surfaces, wood and plastic
Removing discolouration, scale, rust, corrosion, dirt and oxide layers, coatings, paints, old brushed-on coatings, synthetic resins, adhesives, gasket residues and cement and concrete residues.
Structuring, line matting, preparation and roughening up of surfaces
Light deburring work
Cleaning vehicle underbodies and for various other tasks in bodywork construction
Diameter (Ø) | 60 mm |
Max. rotation speed | 10000 rpm |
Recommended rotation speed | 5000 rpm |
Last viewed
Hexagon head sealing plug with collar DIN 910, steel, zinc-plated, blue passivated (A2K)
Sanding belt mount For sanding belts
Countersunk head screw with hexagon socket ISO 10642, A2-070 stainless steel, plain
TiN 90° countersink DIN 335C
Twist drill bit HSCo DIN 338 Type RN MFD VARIO
REFILLO®mat filling can
Engine oil TRIATHLON® Formula DX2 5W-30
Specially fused alumina sanding tip, pink
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, A2-70 stainless steel
Crimping tool with front loading