Nylon Sanding Fleece Disc for interchangeable clamping mandrel
Nylon sand. fleece disc f. intrchng clmpng mandrel
SNDDISC-NYLFAB-D100MM
Register now and access more than 125,000 products
Coarsely structured, elastic, abrasive cleaning sanding fleece made of a special combination of synthetic fibres and evenly embedded abrasive grains (silicon carbide).
Design and properties:
- flexible, open fleece structure
Ideal adjustment to workpiece geometry for optimum surface contact.
Virtually no clogging due to surface abrasion
Uniform and reproducible sanding results
Reduced heat generation - cool sanding
- Continuous exposure of fresh abrasive grain
Uniform, consistent working results and a clean, residue-free surface
- Easy-to-handle sanding power
Minimised risk of damaging workpiece surface or removing too much material
- Free of metals susceptible to corrosion
No contamination of material surfaces
For use on electric drills, straight grinders and flexible shafts
Only for use with suitable clamping mandrels and support flanges
Caution: Flange diameter ≥ half the disc diameter
General working and safety instructions:
The maximum permissible speeds may not be exceeded.
Work only with appropriate protective equipment, such as protective goggles, gloves, ear protectors etc.
Attention: Rough-cleaning sanding fleeces are not suitable for edge sanding. Therefore, only sand along and not against material edges!
Observe operating instructions.
Datasheets(X)
Materials to be processed:
For universal use on virtually all materials. Especially for stainless steel, steel, non-ferrous metals, wood and plastic.
Cleaning welding seams, metal surfaces, wood and plastic
Removing tempering colour, scale, rust, corrosion, dirt and oxide layers, coatings, paints, old brushed-on coatings, synthetic resins, adhesives, gasket residues, cement and concrete residues.
Structuring, line matting, preparation and roughening up of surfaces
Light deburring tasks
Cleaning vehicle underbodies and for various other tasks in car body construction
Diameter x width x shaft diameter | 100 x 13 x 6 mm |
Min./max. recommended rotation speed | 3500-4500 rpm |
Max. rotation speed | 6000 rpm |
Colour | Black |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!
Last viewed
Pneumatic impact screwdriver DSS 1/2 inch Premium COMPACT
Floor nozzle For cleaning large areas of carpet with the spray extraction device
Bevelled-edge chisel In accordance with DIN 5139
Flat connector MINI MIC SRS 1.5
Spring cotter pin With double loop, zinc-plated steel
Lock nut DIN 7967, zinc-plated steel, blue passivated (A2K)
Twist drill bit HSCo DIN 338 Type RN MFD VARIO
1/2" socket wrench insert Wedge shape
Single wire seal (SEAL) For uninsulated cable connector
Hand tap, second tap HSS DIN 352