Welcome to Würth Taiwan For trade customers only

Surface cleaner Activating Cleaner

Surface activating cleaner

Art.-no. 089010060

Prices for customers after login

Surface cleaner Activating Cleaner

Art.-no. 089010060

Prices for customers after login



Exclusively for trade customers

Register now and access more than 125,000 products

Surface optimisation of non-porous surfaces

Suitable for aluminium (anodised), steel, high-grade steel (stainless), galvanised steel (hot-dipped or galvanic), 2-component top coat, (PU, epoxy), 2-component water-based primers and paints, cathodic dip painting, primers (EP/2-component), powder coatings, glass fibre-reinforced plastic (unsaturated polyester), laminate gelcoat or SMC, glass fibre-reinforced plastic (unsaturated polyester), laminate layup, ABS, hard PVC, glass (mineral) and glass ceramic. Not suitable for smoothing or removing adhesives/sealants.

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.

Product information

Würth Catalogue(X)


Safety data sheet

Application area

For cleaning and activating non-porous substrates such as metals, plastics, glazed ceramic and painted surfaces.


Components must be clean, dry and free from dust, oil and grease. Remove non-load bearing or loose layers. Spray the surface with a thin coating of Activating Cleaner and wipe off with a clean cloth or absorbent paper, or spray Activating Cleaner on a cloth and wipe off the adhesive surfaces. Always wipe in one direction. Flash-off time at least 10 min (at 23°C).

Then apply an evenly thin layer of Primer for Metal or Primer for Plastic/Wood/Stone with a brush.

Chemical basis

Solvent mixture with additives






0.79 g/cm³

Min. flash-off time

10 min

Flash-off time conditions

at 23°C and 50% relative humidity

Min. flashing point

12 °C

Shelf life from production

24 Month




400 ml

Weight of content

316 g

Suitable glove:

Nitrile chemical protective glove
Nitrile chemical protective glove
Permeation level: 5
Cotton velour lining
Permeation is the process by which a chemical moves through the material of a protective glove on a molecular level. The time from the initial contact between the chemical and the glove to the permeation of the material is the breakthrough time.
Measured breakthrough time
Permeation level
< 10 min
≥ 10 min
≥ 30 min
≥ 60 min
≥ 120 min
≥ 240 min
≥ 480 min

Important information:

The information given is based on experience and laboratory conditions and is designed as a guide. However, the actual suitability of a glove depends on the individual conditions of its use and must be confirmed by an appropriate test under operational conditions. Given the variety of materials and chemicals used, the possibility of incompatibility or usage problems for the wearer cannot be excluded in individual cases. We would be happy to advise you about optimum solutions.
Art.-no. ! common.detail.customermaterialnumber !

Hazardous Material

Product information

Würth Catalogue

Catalogue page as PDF  | 

Flip catalog


Datasheets ()

CAD Data  | 




Technical information