Magnetiser and demagnetiser
Magnetiser and demagnetiser
MAGN-DEMAGN-RED-52X50X29MM
Register now and access more than 125,000 products
Housing in high-quality, red, break-proof plastic.
Datasheets(X)
For magnetising or demagnetising screwdriver blades, tweezers and similar steel tools
Slowly insert tools through the lower, rectangular opening (+) to magnetise them or through the top opening (–) to demagnetise them. If demagnetisation is not 100% effective, which depends on the steel alloy and diameter, we recommend repeating the procedure on another level after magnetising the tool again.
Length x width x height | 52 x 50 x 29 mm |
Last viewed
6-hole sandpaper with hook-and-loop backing AM LINE (6 inches)
Twist drill bit HSCo DIN 338 Type RN MFD VARIO
C 6.3 TX bit (1/4 inch)
Tool case
Pouch and bag
Engine oil TRIATHLON® Formula DX2 5W-30
No-hole sandpaper with hook-and-loop backing AM LINE (for wooden materials)
No-hole sand paper with hook-and-loop backing AM LINE (green)
Hexagonal bolt with thread up to head
Multi-purpose drill bit Multipack MFD-S 1/4 inch hex shank, 6 pieces