Glazing packer
Glazing packer
GLZNGPCKR-WO.SLPPROT-20X3
Register now and access more than 125,000 products
- Material: Polypropylene
- Ageing-resistant
- Temperature-resistant
- Optimised rib system for high load-bearing capacity
- Verified compatibility with conventional glazing sealants (based on polysulphide, polyurethane and silicone)
- Ventilation channel for vapour pressure compensation (from 32 mm block width and 2 mm thickness upwards)
Datasheets(X)
Block alignment
Blocks should be positioned about one block length from the corners of the glazing units. The distance can be reduced to 20 mm in some cases if the risk of glass breakage is not increased by the frame and the position of the block. Blocks can be positioned about 250 mm from the corners of very wide, fixed glazing units. Glazing blocks must be positioned over a frame fastening point. The number of glazing blocks should be increased accordingly for heavy glazing units.
Thickness | 3 mm |
Width | 20 mm |
Length | 100 mm |
Material | PP - Polypropylene |
Colour | Red |
Last viewed
Cooling system tester with inflatable sealing bladder
Bonded seal
Lock washer with right-angle cross-section, shape B DIN 127, A2 stainless steel, plain
Hexagonal bolt with thread up to the head DIN 933, A2 stainless steel, plain
Pipe and fastening clamp Multifix
Permanent marker set
1/2 inch socket wrench insert metric, hexagon, short
Twist drill bit HSCo DIN 338 Type RN MFD VARIO
Impact insert
Pneumatic chipping hammer DMH 10