End brush Steel, crimped, with shank
Tapered brush steel with shank
CENTFBRSH-12X0,3-S6
Register now and access more than 125,000 products
- Increased stability during brushing
- Crimped wire bristles support each other
- For use on die grinders and drills
- High speeds improve brush performance and service life, especially in the case of straight grinders and manual grinders
- Only the edge tips act on the workpiece. While excessive contact pressure does not improve the result, it does increase the required drive power and reduces the service life of the brush.
- Always wear safety goggles and safety gloves when working with machine brushes!
Datasheets(X)
- Cleaning corners, recesses, holes
- For cleaning moulds/cast parts
- For removing paint and rubber residues
 | |
Diameter (D1) | 12 mm |
Sleeve diameter (D2) | 10 mm |
Usable length of wire (H) | 20 mm |
Wire diameter | 0.30 mm |
Length (L) | 60 mm |
Shank diameter (S) | 6 mm |
Material of wire | Steel |
Design | Corrugated, with shank |
Aggressiveness | Middle |
Suitable for cordless drills (points system) | 2 of 4 points |
Suitable for drill (points system) | 2 of 4 points |
Suitable for straight grinder (point system) | 4 of 4 points |
Max. rotation speed | 20000 rpm |
EN standard | 1083-2 |
Last viewed
Twist drill bit HSS DIN 1897 type RN
Pipe and fastening clamp Multifix
Engine oil Triathlon® Select A 5W-30
3/4" POWERDRIV® socket wrench insert metric, bi-hex
Hand and nail brush With bristles of different thicknesses for effective, gentle manual cleaning
Flat application nozzle for flat application of glue, adhesives and sealants
Pipe and fastening clamp Multifix
Single wire seal (SEAL) For uninsulated cable connector
1/2" socket wrench insert metric, bi-hex, short
Sledgehammer German design in accordance with DIN 1042