Die stocks DIN 225
Threading die holder DIN 225
HOLD-THRDIE-DIN225-SZ2-(M5-M6)
Register now and access more than 125,000 products
Durable design and secure fastening
Housing made of die-cast zinc with knurled clamping screws and 90° tip for mounting die.
Datasheets(X)
The die is placed in the die holder at the height of the middle screw. The screws are tightened with a screwdriver. The die is placed vertically on the workpiece. Can be used on both sides. When cutting, sufficient cutting oil must be added. After two revolutions, the cut can be broken by briefly turning back.
Material | Malleable cast iron |
Internal diameter x height | 20 x 7 mm |
Last viewed
Twist drill bit HSCo DIN 338 Type RN MFD VARIO
Circlip pliers, shape A for shaft circlips
Pneumatic impact screwdriver DSS 1 inch P
Air tool fittings 1500 Series
Tachograph disc For EU tachographs
No-hole sandpaper with hook-and-loop backing AM LINE (for steel materials)
Crimp cable lug, push connector, fully insulated PVC-insulated
Dry lubricant spray PTFE
Clamping pin/clamping sleeve, slotted, heavy-duty design ISO 8752 spring steel plain
Sealing ring, copper, shape A