Structural adhesive, Bond+Seal
Prices for customers after login
Register now and access more than 125,000 products
Outstanding adhesive strength on a wide range of materials and surfaces.
Approved for use with foodstuffs (ISEGA certificate)
Long skin formation time
Can be ground/painted
Following skin formation, can be mechanically machined and painted over without surface activation (perform preliminary tests to check paint compatibility).
Avoids corroding the metal
Do not allow this product to come into contact with alkyd-resin paint systems. Not suitable for glass groove sealing and for expansion joints in the construction sector.
Direct sunlight may result in yellowing of the surface. Not suitable for PE, PP, PTFE, silicone, polystyrene and plastics.
Minimum adhesive thickness: 3 mm. It is essential to use Adhesion Plus products in order to achieve optimum adhesion results.
Can be used where food is processed or stored, e.g. for bonding wall and floor areas in food processing companies.
Clearance certificate no.: 41958 U 16
The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.
For a wide range of bonding and sealing work on surface materials such as metal, painted surfaces, wood, stone, concrete and plastic (polyester and hard PVC).
The surfaces must be clean, dry and free from dust and grease. Processing temperature is between +5°C and +35°C.
Best adhesive results are guaranteed when the surfaces are pretreated with Activating Cleaner (art. no. 089010060) and Primer for Metal (art. no. 089010061) or Primer for plastic/wood/stone (art. no. 089010062). Unhardened material can be removed with glue remover (art. no. 089010063), hardened material can only be removed mechanically.
A minimum adhesive layer thickness of 3 mm is recommended to harness the benefits of thick-coat bonding.
Single component polyurethane
Min./max. skin-formation time
Min./max. skin-formation time /conditions
45-60 min / at 23°C and 50% relative humidity
Full curing speed/conditions
3 mm/d / 23°C and 50% relative humidity, moisture curing
Shore hardness A/conditions
40 / in accordance with DIN 53505
1.25 g/cm³ / prior to hardening, DIN 53479
Min. tensile strength
Min. combined tension and shear resistance
Conditions for tensile strength
in accordance with DIN 53504
Min. longitudinal resistance to tearing
Conditions for resistance to tearing
in accordance with DIN 53515
Elongation at break/conditions
500 % / in accordance with DIN 53504
Min./max. processing temperature
5 to 35 °C
Min./max. temperature resistance
-40 to 90 °C
Max. short-term temperature resistance
Min. flashing point
Glass transition temperature/conditions
-45 °C / in accordance with DIN 53445
Max. change in volume
Shelf life from production/conditions
12 Month / at 10°C to 25°C
Short-term resistance against
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!